Home > Water Heater > Water Heater Temperature Control Not Working

Water Heater Temperature Control Not Working

Contents

This is a safety feature on gas water heaters: When the pilot light is turned off, it does not allow any gas to be delivered, preventing the water from getting heated. I've checked both elements for shorts and they appear fine. These bacteria can cause health problems if your water supply is contaminated. Tyler Cleaned the pilot light and had a new pressure relief valve installed but now I can't turn the heat up past notch B without water coming out of the prv his comment is here

can someone help with maybe a idea / Don Vandervort, HomeTips I am going to guess that the water heater's thermostat is going bad. If there is insufficient hot water, then the next thing to do is check the lower element. Is it covered by insurance? Then I get the hot water. http://www.hometips.com/repair-fix/hot-water-heater-problems.html

Gas Water Heater Not Working

Replacement heating elements are inexpensive and widely available. I checked the elements for continuity and shorts and both appear good. DOE www.energysavers.gov/your_home/water_heating/index.cfm/mytopic=12850 is the base U.S. Let it stay in the tank for 2 hours before draining and refilling it with clean water.

  1. If that doesn't do it, the thermocouple or gas control valve may need adjustment or replacement by a pro.
  2. You will onlyhave hot water in the top of the tank.Water Is Hot But Takes A Long Time To Reheat After Use.Check the upper or top heating element.  It is a
  3. The cold water pressure is fine.
  4. Homhack Creativity 6,590 views 4:21 What's Causing a Water Heater to Trip a Circuit Breaker : Hot Water Heaters - Duration: 2:56.
  5. I'll have to let her know what the problem is.

Relit several times and kept going out, does anyone know what causes this? This is also a good time to test that the temperature-pressure relief valve, which keeps pressure from building up too much in the boiler, is in proper working order. When did this issue start? Water Heater Reset Button Chris Willis Checked my pilot light and it is lit, I turned the thermostat down and turned on hot water running in kitchen sink and watched hot water heater for a

Check first one screw, then the other. My Water Heater Is Not Heating Water I've removed the drywall where the manifold is none of the pipes are viberating and have also checked for vibration at heater to wall location. my water heater's motor would stop after few minutes of turning back on. http://www.water-heater-repair-guide.com/hotwatertemperaturesettings.html I've heard that these Apcom thermastats stink ( and my experience has proved it).

If you find any leak to ground, replace the element. Hot Water Not Hot Enough If there is a drip - you need to replace your pressure relief valve. Sarah Pursche We are having an issue with the pilot. The temp on the water heater is set low.

My Water Heater Is Not Heating Water

As to increase in your gas usage - often gas companies ESTIMATE usage based on previous years data, and charge you for that. http://inspectapedia.com/plumbing/Water_Heater_Diagnostics.php The scale will act as an insulating layer and cause the centerline temperature to increase in order to drive the heat flux through the scale. Gas Water Heater Not Working If so, there is a high limit switch under the upper panel, that needs pushing. Electric Hot Water Heater Not Working But, fear not!

I have not been away. this content Sometimes the wrong breakers are off! The usual complaint is, suddenly there is no hot water. HOMEABOUTCONTACTCOPYDESCRIPTIONPOLICIESPRINTPRIVACY© 2016 Skip navigation UploadSign inSearch Loading... Gas Water Heater Not Hot Enough

Everything lights up i just have what seems to be a leak cause i have an extra flame coming out. Because the first element I removed was rated 4500 watts, I replaced it with a basic cheap 4500-watt one. But be careful - water will be very hot. http://stickersweb.com/water-heater/why-is-my-gas-hot-water-heater-not-working.php I will try my best to reply back as soon as possible.

Low gas pressure or a malfunctioning gas control valve could also cause a pilot light to go out repeatedly. Water Heater Problems Pilot Light Usually rusty colored water is caused by a dissolved anode. Answering simple questions, I will always continue to do, but I have adopted a new policy in which I ask any viewer who seeks, "An Advanced Level Of Help" to post

If you do not have not enough hot water quantity, you are running out of hot water very quickly.

Reply ↓ Angela Kellum May 11, 2016 at 10:13 am I have a gas hot water heater and all of a sudden I have no hot water pressure. Hot water that is not hot enough can be caused by quite a list of problems, some of which are easy to correct. Reply ↓ levab Post authorJune 22, 2016 at 2:07 pm Amanda, Does it take long time to heat up the water? No Hot Water In House Carson, Dunlop & Associates Ltd., 120 Carlton Street Suite 407, Toronto ON M5A 4K2.

Any other suggestions of what could be wrong to find out why not heating the home? How to get more hot water from your water heater Some thermostats settings are marked warm, hot and very hot. Then read the temperature. 2If you don't hear the water heater's burner ignite and/or the water just keeps getting colder, check the pilot light to be sure it hasn’t gone out. http://stickersweb.com/water-heater/water-heater-rv-not-working.php Frequently Asked Questions (FAQs) Click to Show or Hide FAQs Try the search box below or CONTACT US by email if you cannot find the answer you need at InspectApedia.