Home > Washing Machine > Washer Spin Cycle Not Working Properly

Washer Spin Cycle Not Working Properly

Contents

It should have a resistance of approximately 1500 to 1900 ohms. If it isn't caused by any of the faults described above it only really leaves faults on the main PCB (or module), connection faults, motor faults etc. To identify it look for the part with the small plastic tube attached to it. Trev says February 25, 2015 at 6:44 pm Hi I have an LG WM1480FHD, which refuses to count down the last few minutes of some spin cycles (either in a wash his comment is here

After that you need to make sure that the washing machine drain pump is actually working. The worst loads for this problem are single items which are heavy when wet, or small loads, particularly if they have a single heavy item amongst them. First check that the drain pump, drain hose, and wall drain are free of debris. It will fill with water and go through a whole wash cycle. http://removeandreplace.com/2013/05/13/washing-machine-or-washer-dryer-is-not-spinning-draining-how-to-fix/

Washing Machine Not Spinning Properly

YesBy DCA [4 Posts, 1,783 Comments] FlagDecember 27, 20140 found this helpfulThe washer problem could be many possibilities and would probably be difficult for someone to answer from this site. Also check the door strike to ensure that it engages the door lock assembly properly. If the whole thing spins fine, you should be good to go.*Some washing machines are belt driven, some have the tub mounted directly atop the motor.

  • Can we have the model number of your Frigidaire Front Load Washing machine?
  • Try unplugging the washer for 5 minutes and plug back in, set the washer to drain and see if the water will drain out.
  • they are replaceable you can see a video on the website showing you how to check bearings.
  • It may be the timer itself.
  • Andy Trigg (Whitegoodshelp) says January 7, 2015 at 11:15 am Hi Barrie, if there is no actual blockage but the clean pump light comes on it implies the machine thinks it's
  • PCB, electronic modules or however you choose to refer to them do cause issues with spinning, or not spinning, but more on that in a bit.
  • Also during the agitation process, it was making a grinding noise.
  • Watch QueueQueueWatch QueueQueue Remove allDisconnect The next video is startingstop Loading...

I say this assuming that it is no longer under warranty. I ordered it (less than $50.00 including s/h), and then installed it ourselves (me and my husband). Use a flashlight and have a look inside. Washing Machine Drum Not Turning Read the section above at, "Not spinning due to pressure system fault" and follow the link explaining how the pressure system works.

theapplianceman 51,160 views 9:32 Spinner won't spin. Washing Machine Wont Spin Or Drain It never did spin, and then the end of cycle buzz went off. The motor coupling was a weak plastic part which has been replaced with a steel coupling as a direct replacement. http://www.ukwhitegoods.co.uk/help/fix-it-yourself/washing-machine-washer-dryer/2763-washing-machine-a-washer-dryer-will-not-spin It is making a lot of noise, and now during the spin cycle, it aborts.

The unit is only a few months old.Reply 3 Lee October 28, 2016 at 3:04 pmFrigidaire Crown Series - Model FWXB45RGS1My machine goes thru all the cycles but does not spin How To Fix A Washer That Won't Spin If the brushes are not shorter than 1/4" or so, the motor may be worn out. ThanksReply 80 DIY Project Help Tips March 14, 2016 at 2:42 pmJoan Morgan, If you replaced a bad lid switch and it still will not work, make sure the lid switch Machine did not agitate but tub began to slowly rotate.

Washing Machine Wont Spin Or Drain

Both cycles will not agitate the clothes. http://www.thriftyfun.com/Spin-Cycle-Not-Working-on-Washer-1.html This is a guide about spin cycle not working on washer.Ad19 Articles Page 1 All Articles RelevanceShowAll ArticlesQuestionsSortNewestOldestMost HelpfulLeast HelpfulMost AnswersFewest AnswersBest AnswersRelevanceQuestion: Kenmore Washer's Spin Cycle Not Getting Washing Machine Not Spinning Properly Quoted and consulted by journalists and media around the worldAbout Contact Appliance Type Washing Machines Dishwashers Fridges & Freezers Cookers & Ovens Tumble Dryers Buy Appliances Repair Using Safety Spare Parts Whirlpool Washing Machine Not Spinning ReplyWas this helpful?Helpful?

Skip navigation UploadSign inSearch Loading... this content As of now if I try to run it empty the cycle starts but the drum does not rotate. Let us know the model number. -RRReply 33 Dionel Cornelia June 3, 2016 at 6:38 pmI have a Samsung SW12e1 model top loader washer. Machine wasn't getting up to full spin, could hear water pump doing its thing… decided to check the u-bend before it goes into the house waste pipe for blockages first (as Washing Machine Spinning But Clothes Still Wet

By Gianni Answer This QuestionWas this helpful?Helpful? My front loader hadn't drained after its wash throughout the night causing me to open its door this morning and flooding my kitchen. Thanks to you I fixed the Lid switch myself saving $$$!Reply 11 Steven Schutz August 29, 2016 at 6:17 pmOur Kenmore series 80 washer has erratic behavior.. weblink Went to troubleshoot diagnose today and it's back where it started clicking sound, no agitate but slow spin instead. (one caveat: I did not refill the machine today when I tried

Carbon brushes do wear down and this can cause a spinning problem with your washing machine but, the machine has to be a few years old for this to be the Kenmore Washer Not Spinning Kellie says : Reply September 5, 2016 at 10:20 pm Hi I have a bell machine that stopped spinning I emptied the filter found a twisted piece of fabric and a A washing machine will also refuse to do a fast spin if it isn't draining the water, either at all, or just not fully within the set time allowed due to

I'm at my wits' end…Reply 22 DIY Project Help Tips June 20, 2016 at 10:15 pmLana, Check wiring, check drain hose, check to be sure all drain lines in the washer

If the lid switch is in good condition, check the motor coupler as it may be worn out and causing the problem. -RRReply 31 Shawn June 6, 2016 at 2:10 pmI charlie says July 26, 2015 at 8:06 pm Hi i have a hoover front loading machine it will go through a full cycle without clothes even a spin but with clothes By LisaAd Answer This QuestionWas this helpful?Helpful? Samsung Top Loader Washing Machine Not Spinning Thanks for the informationReply 135 Lorri January 7, 2016 at 8:02 amFirst, my compliments to you on the fantastic job you do here and the amount of patience you demonstrate when

Test it to be sure that is not what is causing the issue. I believe it's the reason why the spin cycle won't work. I end up dropping the drain hose to the floor dtain to empty it. http://stickersweb.com/washing-machine/washer-machine-spin-cycle-not-working.php If you try this, does the tub begin spinning?

I turned off the washing machine and notice that it was not spinning and did not rinse. Dave Andy Trigg (Whitegoodshelp) says March 9, 2015 at 12:19 pm Hello Dave, I'm assuming from your description that the motor is spinning and the belt is slipping so not spinning