Home > Ice Maker > Whirlpool Plus Not Working

Whirlpool Plus Not Working

Contents

Seems to have cleared the fault and it working. Loading... I had been swamped with things and really did not have time to address the issue with my ice maker and both my son and I had prayed that it would ApplianceVideo.com 144,823 views 7:01 Whirlpool Refrigerator Diagnostic - No water from dispenser - ED2KHAXVQ01 - Duration: 9:05. http://stickersweb.com/ice-maker/whirlpool-icemaker-not-working.php

Could you advise what else I can do please 12/19/2015 by sarahjjenkins This worked for me. The on/off switch is a slide that will block the beam and stop ice production. MORE ABOUT THIS REPAIR - Customers rate this repair as Easy - 30 - 60 minutes We have 84 installation instructions We have 2 step-by-step videos Inspect the ice maker mold Was this answer helpful?

Whirlpool Refrigerator Ice Maker Not Dispensing Ice

Note that if you are taking air temperature, the door of the freezer should be closed for at least 30 minutes before reading temperature. Low household water pressure or a restriction at the manual shut off valve will also cause the water inlet valve to not shut off completely and create this same condition. Insert the jumper from T to H and close the door. If it won't move in don't force it, but rather try pulling it out a bit.

What model number is your Whirlpool? 12/17/2012 by oldturkey03 Can I change the door from white to black mod#W10632077A April 2 by Joe Johnson I have the same model If the Close Yeah, keep it Undo Close This video is unavailable. I am just happy that it wasn't anything that resulted in an expensive repair. 07-08-2012, 07:42 PM Barking Spider Location: Knoxville 3,817 posts, read 16,068,063 times Reputation: 4176 It Whirlpool Refrigerator Not Making Ice But Water Works Cause 10 Water Filter A clogged water filter can restrict the flow of water to the dispenser and prevent the ice maker from working properly.

Cause 9 Water Filter A clogged water filter can restrict the flow of water to the dispenser and prevent the ice maker from working properly. If the mold thermostat does not have continuity, replace it. (Note: If the ice maker is not cold enough, the mold thermostat contacts will open. This part can be found at AppliancePartsPros.com. https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Refrigerator/53-5-704052-/Whirlpool-Refrigerator-ice-maker-not-working-ED5KVEXVB00 When we installed it the green light flashed once, now it will do nothing.

If you have a whirlpool refrigerator with the ice-bin mounted in the door it will not have the feeler arm, it will have an ice level control optics. How To Reset Whirlpool Ice Maker Published on Oct 11, 2012If you have these symptoms then your ice make may have the same problem as this one.•Tines/fingers down•Ice cubes unmoved in tray•If you remove from freezer and This is the test procedure for this Whirlpool icemaker. 1. Excited by another challenge, I grabbed my tools and test equipment, then started pulling things apart.

  • Whirlpool Icemaker Repair-Optics Test In this section of this Whirlpool icemaker repair guide I will walk you though diagnosing the ice level optics on Whirlpool refrigerators with the ice-bin mounted in
  • That's part 2198597.
  • I used the "wire trick" to attempt to manually trigger the ice making process.
  • To reset it, you will have to have the door open.
  • If the icemaker module is defective, the ice maker won’t make or dispense ice.
  • If there are no cubes or very small cubes, then you should look for issues with the water fill system.

Whirlpool Fridge Ice Maker Not Working

The valve requires at least 20 psi to function properly. http://applianceassistant.com/Refrigerator-Repair/Ice-Makers/Whirlpool-In-Door-Ice-Maker-Troubleshooting.php I need to get the standing water drained out of the bottom and need advice Was this answer helpful? Whirlpool Refrigerator Ice Maker Not Dispensing Ice The optics is just two sensors, one on each side of the freezer and when ice gets high enough to block the sensors it cuts the icemaker off. Whirlpool Refrigerator Ice Maker Not Getting Water Most heat release ice makers will have a removable cover at the front.

DIY. http://stickersweb.com/ice-maker/whirlpool-in-door-ice-maker-not-working.php You can try chatting with one of our friendly associates. Now close the door, this should reset your dishwasher. Find out more » Total: $85.61 Add to Cart Cause 6 Low Water Pressure from House Supply The home may have insufficient water pressure. Whirlpool Ice Maker Removal

No- If there is no ice in the mold take that jumper wire and place one end in the hole marked V and the other end in the hole marked L Searching with your model will also give you access to even more information about this symptom and instructions on how to install your repair part. The diagnostic cycle ran for 15 minutes. http://stickersweb.com/ice-maker/whirlpool-ice-machine-not-working.php Please allow up to 5 seconds… DDoS protection by CloudFlare Ray ID: 302b2f1c64681177 Like ApplianceAssistant on Facebook!

Will get back on if it still has any issues Was this answer helpful? Whirlpool Gold Ice Dispenser Not Working The lights flash and it looks like it is running a diagnostic. Result: The red status light should be steady on.

I hope you continue to do so.

If the motor does not start, you can verify that you have power to the ice maker at test points “L” and “N”. Yes No Voted Undo Score 11 Cancel Comments: Wil, did it work before you replaced the door latch? March 9 by Nellie Fauth Thank you so much!!! Whirlpool Bottom Freezer Ice Maker Not Working To access this modular simply remove the cover off the front of the icemaker, note that on some side-by-side refrigerators the icemaker is mounted sideways and you must take the icemaker

Need help please?? Special note for bottom freezers the icemaker may not respond to the jumper wire test unless you close the door or press the door switch. Parts Icemaker Module for your Whirlpool Refrigerator RepairClinic Item #961550 Repair kit. http://stickersweb.com/ice-maker/whirlpool-ice-maker-not-working.php Sign in to make your opinion count.

Start here All parts purchased from AppliancePartsPros.com have 365 day no questions asked return policy. All rights reserved. Place one end of the jumper wire in the hole marked H and the other end in the hole marked T. Subscribe ApplianceAssistant on Youtube! Menu Home Washers Dryers Refrigerators Dishwashers Stoves Videos Manuals Parts Whirlpool In-Door Ice System Troubleshooting Guide Find Ice Maker Repair Parts For general information visit the "How

First thing you should check is the feeler arm (not on models with the ice bin mounted on the freezer door).