Home > Ice Maker > Whirlpool Ice Maker Not Working Infrared

Whirlpool Ice Maker Not Working Infrared


Reply Ryan Posted on March 16, 2015 Since the light from the optics board is infared, you cannot see it with the human eye. Next close the door to align the optics and reconnect power. I was so surprised and thankful that because we live in the same town you personally delivered the part to me! Parts Icemaker Module for your Whirlpool Refrigerator RepairClinic Item #1469018 Refrigerator icemaker control module and motor assembly. http://stickersweb.com/ice-maker/whirlpool-infrared-ice-maker-not-working.php

All other functions in the fridge and freezer appear to work fine with the exception of the icemaker and emitter board. - Is there a separate power board? - Kitchen aid It did and is now making ice. Like ApplianceAssistant on Facebook! Help Me Find My Model Number Select Appliance Type: Air Conditioner Dishwasher Dryer Freezer Ice Machine Microwave Range/Stove/Oven Range Vent Hood Refrigerator Trash Compactor Washing Machine Model Number Locations Side Wall

Whirlpool Ice Maker Reset Button

Cause 6 Low Water Pressure from House Supply The home may have insufficient water pressure. As soon as you delievered the part to me I had it exchanged and back in the freezer within 10 minutes. Find out more » Total: $213.92 Add to Cart Cause 10 Water Filter A clogged water filter can restrict the flow of water to the dispenser and prevent the ice maker

In addition to the step by step pictures and details to change those boards, you will to need to get replacement optical boards. Hmmm. Harrison,Thank you so much for your excellent customer service and website! Whirlpool Conquest Ice Maker Parts It did the same as few days ago and another punchin/shakedown worked.

Follow ApplianceAssistant on Twitter! Whirlpool Conquest Ice Maker Not Dispensing Ice When the thermostat or sensor on the icemaker tray reaches about 15 degrees Fahrenheit, the motor cycles to release the ice cubes. So I decided to replace that icemaker anyway. http://appliancejunk.com/forums/index.php?topic=44.0 This part can be found at AppliancePartsPros.com.

Then it started making ice again. W10757851 Works like a charm and its great to see a full door of ice. I installed the part and now I have ice. The IR sensor passes the light test (although at times it does not light at all when I have been screwing with the ice maker in and out).

Whirlpool Conquest Ice Maker Not Dispensing Ice

So I took the ice maker apart this past Sunday night (I finally had time to mess with it), and ordered the part from a local appliance store. https://partsdr.com/blog/4389102-ice-level-optics-board-diagnostics-replacement/ If you want to avoid any delay, make sure your PayPal email address is correct. Whirlpool Ice Maker Reset Button Since the module motor assembly seems to work when you jumped it, and at times the status light does not come on, There's a good chance the IR boards are bad. Whirlpool In Door Ice Maker Not Working When I look at the optics beam hole on the left side I do not see any flashing lights, does that mean the control boards are bad or is it the

Installed the part and had ice in no time. news Step 1. Parts Door Switch for your Whirlpool Refrigerator RepairClinic Item #3071 Refrigerator door switch. Return From Whirlpool Icemaker Repair Guide Appliance-repair-it.com is a free service but it cost to keep it up and running. Kitchenaid Ice Maker Sensor

Reply Steve Posted on September 16, 2015 I have a worldpool gold series. Notify me of new posts by email. I also did some measurements on the module with a multi meter to ensure the 120 volts are present and the heater is good. ( I will admit that readings on have a peek at these guys Thanks for the Ice Maker fix.

To test the optics board, perform the steps at the top of the page. Whirlpool Ice Maker Control Board Unplugged the refrigerator for about 20 minutes. Within the instructions, I will show you how to order your part (based on your model number of your refrigerator).

Disconnect the wire harness on the back side and then remove the two Phillips screws to release the receiver control board from the housing.  Re-install the receiver board in the reverse

  1. The best way to do this is to unplug the refrigerator and remove the line from the water valve and blow through it.
  2. Open the Freezer door for and activate the freezer door switch 3 times within 10 seconds (see Figure 6 above). 6.
  3. If you are unable to read the attachment that is automatically sent to you once you donate via PayPal (or you do not see an email reply within 10 minutes), try
  4. That made me understand it wasn't electrical or mechanical.
  5. I ordered a new set of controller boards for the level controller and the system began working a day before the boards arrived.

It is a very easy and quick fix...if you can determine from the instructions above that your optical boards are bad, then you will have no problem replacing the optic boards How To Replace The Whirlpool Ice Maker Optic Control Boards W10757851 First, unplug the refrigerator. I left you feedback. Whirlpool W10757851 I probably wouldve paid double by hiring someone to do this very simple repair!

Or, if you don't use PayPal, then your payment can be sent to: Absolute Technologies, Inc.Attention: Ice Maker RepairPO Box 601Holly Springs, NC 27540 Please include your email address so thatyour Find your part: When repairing icemakers it is important to know how much ice the icemaker should produce. Thanks Reply Jose Posted on March 14, 2015 I have a kitchenAid which is not make ice. http://stickersweb.com/ice-maker/whirlpool-ice-maker-not-working.php Within the instructions, I show you how you can get a set of boards with a 1 year warranty and a guarantee that if it doesn't fix your problem, you can

Reply skw Posted on May 7, 2015 I found my optic control board full of frozen water along with frozen water up into the water line frozen into the ice fill Put a piece of electrical tape over the jumper as the paper clip will be "hot" with power and could kill you if you touch it.You now have the IR control Find out more » Total: $10.79 Add to Cart Cause 8 Door Switch The door switch turns off the ice and water dispenser when the refrigerator door is open.