Home > Ice Maker > Whirlpool Automatic Ice Maker Not Working

Whirlpool Automatic Ice Maker Not Working

Contents

Back to Top More You May Also Like... Top 5 Reasons Refrigerator Is Freezing Food? What could cause this!? After a few months ice starts to build up on the evap. http://stickersweb.com/ice-maker/whirlpool-refrigerator-automatic-ice-maker-not-working.php

Sbru57 I have a GE refrigerator/freezer with ice maker on my boat. Would this indicate that my ice maker is defective? If the light is still blinking the same as before you pressed the flap the optics are bad. Did you figure out what exactly was problem? ?

Whirlpool Refrigerator Ice Maker Not Getting Water

Everything works great. Steve Jenkins Hi, Michael. A. Cause 9 Water Filter A clogged water filter can restrict the flow of water to the dispenser and prevent the ice maker from working properly.

  1. I am at a loss.
  2. Cause 2 Water Inlet Valve The water inlet valve is an electrically-controlled valve that opens to supply water to the dispenser and ice maker.
  3. Next press in on the flapper to unblock the optics.
  4. The valve requires at least 20 psi to function properly.
  5. My manual is of no help at all, it doesn't mention anything about this.
  6. If you find that the refrigerator is not cooling properly click here Special note for bottom freezers the icemaker may not respond to the jumper wire test described below unless you
  7. Cars.
  8. Remove and clean the screen or replace the valve.

Buy on Amazon. PartSelect.com Home Contact About Us Help Privacy Policy Terms of Use Blog Just For Fun! Most heat release ice makers will have a removable cover at the front. Whirlpool Ice Maker Removal I have the new lever part but can't figure out how to get the back of the freezer door off.

If the light blinks once followed by a one second delay, the optics are bad and needs replacing. Whirlpool Refrigerator Not Making Ice But Water Works fan . The water filter should be replaced about every six months to maintain proper water flow and ensure water quality. You can buy an ice maker motor module on Amazon.

It's a $2 Chinese motor, so maybe I should feel lucky I even got 7 years! Whirlpool Bottom Freezer Ice Maker Not Working Icemakers typically dump once every 1-2 hours An icemaker that dumps once an hour has strong icemaker production and an icemaker that dump once every 2 hours is weak but still B. Makes 8 radius ice cubes.

Whirlpool Refrigerator Not Making Ice But Water Works

C. you could try here Other safety guidelines to follow when attempting home appliance repair are beware of moving parts, wear work gloves if placing hands near mechanical or electrical areas, and always use the right Whirlpool Refrigerator Ice Maker Not Getting Water Our ice maker is working but the bucket won't fit in and so ice cannot be dispensed through the door. Automatic Ice Maker Repair Kevin Swainson I have a Samsung model RSH5UBBP.

I hope this helps Wanda Brown I have an Amana side by side ice maker and water dispenser. http://stickersweb.com/ice-maker/whirlpool-ice-maker-refrigerator-not-working.php Kathryn McMath My bucket freezes up. A bad tap valve—the little device that connects the ice maker's water supply tube to the water pipe—may cause the problem where the ice maker’s supply tube connects to the water Need to defrost a bit (and hold in the release button) before I can finally wiggle it loose Danil My Kenmore side by side with water/ice dispenser in door has a Kitchenaid Ice Maker Not Making Ice

The water filter should be replaced about every six months to maintain proper water flow and ensure water quality. it fills up the ice tray, freezes the ice cubes but does not eject them. There are usually test points in the module that a technician can use to further diagnose problems with the module. http://stickersweb.com/ice-maker/why-is-my-automatic-ice-maker-not-working.php Open the freezer door (make sure that the freezer door has been closed for a minimum of 10 seconds prior to opening the door).

Water Fill Tubes Start Your Repair Here We have fill tubes for thousands of models Search Need Help Finding Your Model Number? Whirlpool French Door Refrigerator Ice Maker Not Working Low household water pressure or a restriction at the manual shut off valve will also cause the water inlet valve to not shut off completely and create this same condition. Insert the jumper from T to H and close the door.

Be sure the water supply line isn’t kinked behind or beneath the refrigerator (1/4-inch copper tubing is much better than plastic fill line to prevent kinks). 2See if the fill tube

For In-Door Ice models. $85.61 Quantity: In Stock › Same Day Shipping Order by 4:30 PM ET, this part ships TODAY! 365-Day Return Policy Return any item for any reason within Typically it will take 24-48 hours for an icemaker bin to fill and longer if the refrigerator is just starting up. ft. Whirlpool Ice Maker Leaking Water Into Bin Because they said the original packaging was damaged.

Did you ever find a solution? I'm having the same problem William Branner To clarify, I have removed all ice, but the bucket won't come out and I'm wondering if whatever's holding it has something to do Take a six-inch piece of insulted wire and skin about ½ inch on each end. http://stickersweb.com/ice-maker/whirlpool-ice-maker-not-working.php I look for those kinds of changes over time.

But chances are high that the problem's going to lie with one of the electrical points in the system, which is going to either be the motor that rotates the arms to eject the Parts Water Inlet Valve for your Whirlpool Refrigerator RepairClinic Item #1938614 Refrigerator water inlet valve. -Some models use a separate customer connection fitting, if that is needed see Recommended Parts. $65.99 any ideas? Also buying a power surge to avoid all this again.

Masha Sanders My bail wire no longer stays up. Results: -Two flashes repeated once means the ice maker’s optics are blocked or defective. -A steady on light for 5 seconds means the ice maker’s optics boards are working properly. -If Glad you have the parts on hand so your downtime is minimal when it does! 🙂 Steve Jenkins It could be the switch that triggers the dispenser motor, or it could Each filter provides 200 gallons of filtered water and should be changed every 6 months to ensure proper contaminant removal and flow rate.